Διάφορα Υπάρχουν 21 προϊόντα.

• 

  24,00 € Διαθέσιμο

  BBC micro:bit go Starter Kit

  With the complete micro:bit go set, users can give free rein to their creativity. The set includes all necessary parts for the introduction to working with the micro:bit as well as suggestions for the realization of creative ideas. A micro:bit, a USB cable, a battery holder and 2 AAA batteries. A short manual with 4 project examples are included.

  24,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  17,80 € Διαθέσιμο

  NUCLEO STM32F4 STM32F401RE 512K

  STM32 Nucleo-64 development board with STM32F401RE MCU, supports Arduino and ST morpho connectivity

  17,80 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  22,30 € Διαθέσιμο

  NXP FRDM-KL25Z Freedom Development Platform

  The Freedom KL25Z is an ultra-low-cost development platform for Kinetis L Series KL1x (KL14/15) and KL2x (KL24/25) MCUs built on ARM® Cortex®-M0+ processor.

  22,30 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  19,00 € Διαθέσιμο

  BBC micro:bit (Board Only)

  The BBC micro:bit is a pocket-sized codeable computer with motion detection, a built-in compass, LED display, and Bluetooth technology built in.Each element is completely programmable via easy-to-use software on a dedicated website (www.microbit.co.uk) that can be accessed from a PC, tablet or mobile.

  19,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  14,00 € 19,00 € Διαθέσιμο

  Προσφορά!

  Espressif ESP32D Development Kit - WiFi &...

  Manufacturer: ESPRESSIF Receiver sensitivity: -98dBm Transmitter output power: 19.5dBm Ciphering: AES, WPA, WPA2-PSK, WPS Supply voltage: 2.2-3.6V DC Communictions protocol: FTP, HTTP, IBM MQTT, IPv4, IPv6, SSL, TCP, UDP Network type: Bluetooth Smart, WiFi Band: 2,412G-2,484GHz GPIO, I2Cx2, I2Sx2, SDIO, SPIx3, UARTx3, USB

  14,00 € 19,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  6,80 € Διαθέσιμο

  ESP-WROOM-32 Wifi & Bluetooth Module

  Manufacturer: ESPRESSIF Version: ESP-WROOM-32 (4MB) Receiver sensitivity: -98dBm Transmitter output power: 19.5dBm Ciphering: AES, WPA, WPA2-PSK, WPS Supply voltage: 2.2-3.6V DC Communictions protocol: FTP, HTTP, IBM MQTT, IPv4, IPv6, SSL, TCP, UDP Network type: Bluetooth Smart, WiFi Band: 2,412G-2,484GHz GPIO, I2Cx2, I2Sx2, SDIO, SPIx3, UARTx3

  6,80 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  19,20 € Διαθέσιμο

  NUCLEO-64 STM32F446RE

  The STM32 Nucleo board provides an affordable and flexible way for users to try out new ideas and build prototypes with any STM32 microcontroller line, choosing from the various combinations of performance, power consumption and features.

  19,20 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  14,10 € Διαθέσιμο

  NUCLEO-64 STM32F103RE

  The STM32 Nucleo board provides an affordable and flexible way for users to try out new ideas and build prototypes with any STM32 microcontroller line, choosing from the various combinations of performance, power consumption and features. 

  14,10 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  1,80 € Εξαντλημένο

  micro:bit Battery holder 2xAAA with switch

  micro:bit Compatible Battery holder 2xAAA On/Off switch

  1,80 €

  Προσθήκη στο καλάθι Περισσότερα

  Εξαντλημένο
• 

  7,00 € Διαθέσιμο

  Προσφορά!

  ESP8266 ESP-12E NodeMcu V3 Lua Board CH340...

  WiFi Module – ESP-12E Uses CH340G replace the CP2102 USB: micro USB port for power, programming and debugging Headers: 2 x 15p 2.54mm pitch (with access to GPIOs, SPI, UART, ADC, and power pins) Buttons: Reset, Flash Power: 5V Size: 50 x 25 x 14 mm

  7,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  11,80 € Διαθέσιμο

  micro:bit Edge Connector Breakout Board

  This is an edge connector expansion board designed for micro:bit, breakout the I/O pins to 2.54mm pitch pinheaders for easy use. Dimension: 82.05mm x 36.10mm Through holes diameter: 2mm Edge breakout for micro: bit

  11,80 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  31,30 € Διαθέσιμο

  DFRobot micro:Maqueen ROB0148

  Supply Voltage: 3.5V~5V DC Infrared Grayscale Sensor x 2 Buzzer x 1 Infrared Receiver x 1 LED Lights x 2 RGB Ambient Light x 4 SR04, SR04P Ultrasonic Interface(5V) x 1 IIC Interface (3.3V) x 1 Gravity Extension Interfaces (P1, P2) x 2 N20 All-metal Gear Motor x 2 Max Rotate Speed: 133 rpm Motor Drive Mode: PWM motor drive Dimension: 81x85x44 mm

  31,30 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  7,70 € Διαθέσιμο

  ESP8266 ESP-12E NodeMcu Lua Board CP2102...

  WiFi Module – ESP-12E USB: micro USB port for power, programming and debugging Headers: 2 x 15p 2.54mm pitch (with access to GPIOs, SPI, UART, ADC, and power pins) Buttons: Reset, Flash Power: 5V Size: 50 x 25 x 14 mm

  7,70 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  24,80 € Διαθέσιμο

  MSP-EXP430FR5969 USB LaunchPad Evaluation Kit

  MSP430 ULP FRAM technology based MSP430FR5969 16-bit MCU 64KB FRAM / 2KB SRAM 16-Bit RISC Architecture up to 8-MHz FRAM access/ 16MHz system clock speed 5x Timer Blocks Analog: 16Ch 12-Bit differential ADC, 16Ch Comparator Digital: AES256, CRC, DMA, HW MPY32 0.1F SuperCap for standalone power Onboard eZ-FET emulation Back-channel UART via USB to PC

  24,80 €

  Προσθήκη στο καλάθι Περισσότερα

  Διαθέσιμο
• 

  69,00 € Εξαντλημένο

  Intel® Edison Module EDI2.SPON.AL.S (IoT)

  Designed for expert makers, entrepreneurs, and industrial IoT companies, the Intel® Edison module provides ease-of-development with a fully open source hardware and software development environment for a range of products. 

  69,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Εξαντλημένο
• 

  15,90 € Εξαντλημένο

  MSP-EXP430G2 LaunchPad Development Kit

  The MSP-EXP430G2 low-cost experimenter board called LaunchPad is a complete development solution Manufacturer: Texas Instruments Tool Is For Evaluation Of: MSP430G2xx, MSP430F20xx Core: MSP430 Data Bus Width: 16 bit Interface Type: USB

  15,90 €

  Προσθήκη στο καλάθι Περισσότερα

  Εξαντλημένο
• 

  7,00 € Εξαντλημένο

  MI:Power board for the BBC micro:bit

  The MI:power board for the BBC micro:bit brings real portability to your wearable projects. The stylish, lightweight PCB is designed to fit snugly against the BBC micro:bit and features a built in buzzer and 3V coin cell holder. Please Note: BBC micro:bit is NOT included.

  7,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Εξαντλημένο
• 

  8,00 € Εξαντλημένο

  bread:bit breakout for BBC micro:bit

  The bread:bit makes it a breeze to connect your micro:bit to your breadboard. Simply solder the provided male headers and seat it in the middle of your breadboard. Alternatively you can solder female headers (not included) This board comes pre-populated with an 80 way surface mount edge connector.

  8,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Εξαντλημένο