Περιφερειακά Υπάρχουν 50 προϊόντα.

• 

  10,50 € Available

  Raspberry Pi Official Power Supply 5.1V...

  The Official Raspberry Pi Power Supply! This PSU supports up to 2.5A of current, so it won't let you down when powering hungry devices through your Raspberry Pi 3 5.1V 2.5A Output 1.5m Cable Black with Raspberry Pi Logo Input Voltage AC Max: 264V Input Voltage AC Min: 90V Output Connector: USB Micro Output Voltage Nom.: 5.1V Adaptor - EU/UK/US/AUS

  10,50 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  3,30 € Available

  Νέο

  Heatsink Set Copper & Aluminum for...

  Compatible with Raspberry Pi 3 Material: Copper & Aluminum Package: 3 pieces

  3,30 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  4,00 € Available

  Heatsink Set Copper for Raspberry Pi (3-pack)

  Compatible with Raspberry Pi 3 Material: Copper Size: 12x13x5.4mm,15x15x1mm Package: 3 pieces

  4,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  2,50 € Available

  Photo Interrupter - Car Speed Sensor

  Ιntelligent car speed measurement module Photoelectric Output 5V, TTL level

  2,50 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  12,50 € Available

  SparkFun XBee Explorer WRL-11373

  The SparkFun XBee Explorer Regulated takes care of the 3.3V regulation, signal conditioning, and basic activity indicators (Power, RSSI and DIN/DOUT activity LEDs). It translates the 5V serial signals to 3.3V so that you can connect a 5V (down to 3.3V) system to any XBee module.

  12,50 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  3,20 € Available

  Film Strain Gauge 120R 9x4mm

  Model: BX120-4AA Size: 9mmx4mm With 4cm silver plated copper wire Suitable temperature: -30...70°C Sensitivity coefficient and dispresion: 2.1 +/-2% Connection: solder pads Resistance: 120R Origin: CHINA *with soldered leads

  3,20 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  9,50 € Available

  Νέο

  Τροφοδοτικό Goobay MicroUSB 5V 2.5A με...

  Black Color Input Voltage AC Max: 100 - 240 (AC) V Output Connector: USB Micro Output Voltage Nom.: 5.0V Max Current: 2.5A with Power Switch

  9,50 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  8,00 € Available

  T-Cobbler Plus GPIO Breakout & Ribbon...

  You can plug the 40-pin GPIO cable between the Raspberry Pi and the extension board. Package included: 1 x GPIO extension Board for Raspberry Pi 1 x 40 pin cable Features: No soldering required Labeled pins Breadboard compatible Break out power, GPIO, I2C and SPI pins *Breadboard not included

  8,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  11,00 € Available

  Προσφορά!

  Sandisk micro SDHC 32GB Class 10

  Manufacturer: SANDISK Type: SD HC Micro Storage Capacity: 32GB Speed Class: Class 10 Suitable for iPad, Tablet, Cellular, Digital Camera, GPS, Mp3, Raspberry etc.

  11,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  6,40 € Available

  Adafruit MCP4725 Breakout 12-Bit DAC

  Your microcontroller probably has an ADC (analog -> digital converter) but does it have a DAC (digital -> analog converter)? This breakout board features the easy-to-use MCP4725 12-bit DAC. Control it via I2C and send it the value you want it to output, and the VOUT pin will have it. Great for audio / analog projects, such as when you can't use PWM...

  6,40 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  3,50 € Available

  BreadBoard Half-Size 400 Tie Point Clear

  This is a half-size breadboard with 400 tie points. It is solderless allowing to easily connect circuits of electronic components. 400 tie point breadboard Color: Clear 30 x 5 x 2 & 2x5x10 points ABS plastic material Completely reusable Coordinates for easy component placement Stackable Accepts a variety of wire sizes (20-29 AWG) Dimensions: 82mm x...

  3,50 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  1,20 € Available

  Photoresistor Module KY-018

  The Photo Resistor Module is used to indicate the presence or absence of light. The module can also be used to measure light intensity. This module allows for easy sensing of light levels from within your Arduino controller. Photosensitive Sensor Operating voltage 5V

  1,20 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  1,20 € Available

  MAX3232 RS232 to TTL Serial Module DB9...

  Chip: MAX232 RXD / TXD transceiver communication indicator Connector: DB9 Size: aprox. 32mm x 32mm x 16mm Interface: VCC. RXD, TXD, GND

  1,20 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  2,50 € Available

  GY-302 BH1750 Light Sensor Module

  Light intensity sensor module Data output range resembles luminance from 0-65535 lux I2C Interface No external parts required Provides simple digital output

  2,50 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  2,00 € Available

  MicroSD Module with SPI interface (for...

  Supports Micro SD cards, Micro SDHC card (high speed card) Level conversion circuit board that interfaces level for 5V or 3.3VPower supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit boardStandard communication interface SPI interface Perfect for Arduino Projects and more 4xM2 screw positioning holes for easy installation

  2,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  7,00 € Available

  HC-06 Serial Bluetooth module (for Arduino)

  TTL data transparent transfer between a host Bluetooth device.  Coverage: 10m Built in 2.4 antenna.  Power input: 3.3 Dimensions: 44mm x 16mm x 7mm Weight: 8gr Bluetooth version: V2.0+EDR Default Baud Rate: 9600,8,1,n.

  7,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  2,50 € Available

  BreadBoard Half-Size 400 Tie Point White

  This is a half-size breadboard with 400 tie points. It is solderless allowing to easily connect circuits of electronic components. 400 tie point breadboard Color: White 30 x 5 x 2 & 2x5x10 points ABS plastic material Completely reusable Coordinates for easy component placement Stackable Accepts a variety of wire sizes (20-29 AWG) Dimensions: 82mm x...

  2,50 €

  Προσθήκη στο καλάθι Περισσότερα

  Available
• 

  4,00 € Εξαντλημένο

  Raspberry Pi GPIO extension board V3.0

  You can plug the 26-pin ribbon cable between the Raspberry Pi and the extension board. Features: No soldering required Labeled pins Breadboard compatible Break out GPIO

  4,00 €

  Προσθήκη στο καλάθι Περισσότερα

  Εξαντλημένο