New products

Motor Control There are 6 products.

Showing 1 - 6 of 6 items
  • 4,50 € Available

    Drives 4 DC or 2 stepper or 2 Servo motors Up to 4 bi-directional DC motors with individual 8-bit speed selection Up to 2 stepper motors (unipolar or bipolar) with single/double coil or interleaved stepping 4 H-Bridges: 0.6A per bridge (1.2A peak current) with thermal protection, can run motors on 4.5V to 36V DC 2 external terminal power interface, for...

    4,50 €
  • 1,00 € Available

    Suitable for 28BYJ-48 Step Motor Stepper motor driver board with ULN2003 A, B, C, D four-phase LED indicates the status of the stepper motor work. Stepper motor with a standard interface, when used directly pluggable. Drive Module Board Size:28mm x 28mm x 20mm *Step Motor is not included

    1,00 €
  • 4,00 € Available

    Double H bridge drive Chip: L298N (ST) Logical voltage: 5V Drive voltage: 5V-35V Logical current: 0mA-36mA Drive current: 2A(MAX single bridge) Max power: 25W Size:43 x 43 x 26mm

    4,00 €
  • 25,10 € Out of stock

    The Arduino Motor Shield is based on the L298, which is a dual full-bridge driver designed to drive inductive loads such as relays, solenoids, DC and stepping motors. Operating Voltage: 5V to 12V Motor controller: L298P, Drives 2 DC motors or 1 stepper motor Max current: 2A per channel or 4A max (with external power supply) Current sensing: 1.65V/A

    25,10 €
    Add to cart More
    Out of stock
  • 3,20 € Available

    A4988 is a complete microstepping motor driver with built-in translator for easy operation.Package included: 1 x Step motor driver module 1 x Heatsink

    3,20 €
  • 5,80 € Available

    5V compatible, 3.3V microcontroller can be used 6 "address select" pins for configuring up to 62 ICs on a single I2C bus PWM frequency adjustable up to approximately 1.6kHz 12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate) Configurable as push-pull or open-drain output The output enable pin can disable all output quickly

    5,80 €
Showing 1 - 6 of 6 items