resistive-thin-film-pressure-sensor-rfp602-gr Μεγαλύτερη προβολή

Resistive Thin Film Pressure Sensor RFP602

AAA-000221

Νέο προϊόν

  • Sensor Name: RFP Membrane Pressure Sensor
  • Model: RFP-602
  • Sensor type: single point
  • Sensitive area shape: round
  • Total length of sensor: 10mm (±1mm) in diameter
  • Sensor thickness: 0.2mm
  • Terminal Type: Male Terminal
  • Sensor principle: piezoresistive
  • Service life: > 500,000 times
  • Response time: us level
  • Working temperature: -25 ° C ~ 70 ° C
  • Film material: polyester
  • Range: 5kg

Περισσότερες λεπτομέρειες

Διαθέσιμο

13,00 € με Φ.Π.Α

Άλλες πληροφορίες

Here's a small tutorial on how to connect a Resistive Thin Film Pressure Sensor RFP602 to an Arduino, along with example source code for reading the pressure value:

Step 1: Gather the Required Equipment:

  • Arduino board (such as Arduino Uno)
  • Resistive Thin Film Pressure Sensor RFP602
  • Breadboard
  • Jumper wires

Step 2: Understand the Resistive Thin Film Pressure Sensor RFP602:

  • The RFP602 is a resistive type pressure sensor that changes its resistance based on the applied pressure.
  • It typically has three pins: Vcc, Ground, and Signal.
  • The Signal pin is the output pin that connects to the Arduino to read the pressure value.

Step 3: Connect the RFP602 to the Arduino:

  1. Connect the Vcc pin of the RFP602 to a 5V pin on the Arduino.
  2. Connect the Ground pin of the RFP602 to a Ground pin on the Arduino.
  3. Connect the Signal pin of the RFP602 to an analog pin on the Arduino, for example, A0.

Step 4: Read the Pressure Value in Arduino:

Here's an example Arduino code to read the analog value from the Signal pin of the RFP602 and convert it to pressure in kilopascals (kPa):

// Define the analog pin used to read the pressure sensor
const int pressureSensorPin = A0;

void setup() {
  // Initialize serial communication for debugging
  Serial.begin(9600);
}

void loop() {
  // Read the analog value from the pressure sensor
  int analogValue = analogRead(pressureSensorPin);

  // Convert the analog value to pressure in kPa
  float pressure_kPa = analogValue * 0.2; // Assuming a linear relationship between analog value and pressure

  // Print the pressure value to the serial monitor
  Serial.print("Pressure (kPa): ");
  Serial.println(pressure_kPa);

  delay(1000); // Delay for 1 second
}

This code reads the analog value from the pressure sensor using the analogRead() function, converts it to pressure in kilopascals (kPa) assuming a linear relationship, and prints the pressure value to the serial monitor. You can customize the conversion formula or calibration parameters based on the specifications provided by the manufacturer or specific to your application.

That's it! You have now connected and read data from the Resistive Thin Film Pressure Sensor RFP602 using an Arduino. Make sure to refer to the datasheet and manufacturer's documentation for any additional information or specifications specific to your sensor model.

Αξεσουάρ

Πελάτες που αγόρασαν αυτό το προϊόν, αγόρασαν επίσης: