l293d-h-bridge Μεγαλύτερη προβολή

L293D H-Bridge

PRD-000369

Νέο προϊόν

Applications

  • Stepper Motor Drivers
  • DC Motor Drivers
  • Latching Relay Drivers

Features

  • Wide Supply-Voltage Range: 4.5 V to 36 V
  • Separate Input-Logic Supply
  • Internal ESD Protection
  • High-Noise-Immunity Inputs
  • Output Current 1 A Per Channel
  • Peak Output Current 2 A Per Channel
  • Output Clamp Diodes for Inductive Transient Suppression

Περισσότερες λεπτομέρειες

Διαθέσιμο

0,80 € με Φ.Π.Α

Άλλες πληροφορίες

The most common method to drive DC motors in two directions under control of a computer is with an H-bridge motor driver. H-bridges can be built from scratch with bi-polar junction transistors (BJT) or with field effect transistors (FET), or can be purchased as an integrated unit in a single integrated circuit package such as the L293. The L293 is simplest and inexpensive for low current motors, For high current motors, it is less expensive to build your own H-bridge from scratch.

The L293 is an integrated circuit motor driver that can be used for simultaneous, bi-directional control of two small motors. Small means small. The L293 is limited to 600 mA, but in reality can only handle much small currents unless you have done some serious heat sinking to keep the case temperature down. Unsure about whether the L293 will work with your motor? Hook up the circuit and run your motor while keeping your finger on the chip. If it gets too hot to touch, you can't use it with your motor. (Note to ME2011 students: The L293 should be OK for your small motor but is not OK for your gear motor.)

Αξεσουάρ

Πελάτες που αγόρασαν αυτό το προϊόν, αγόρασαν επίσης: